Swiftkit® System
 Swiftkit® carbon filter installation Carbon filters for AHU’s
The AAC AHU Swiftkit® is specifically designed for Air Handling Unit manufacturers to incorporate Activated Carbon Filters into their AHU's at low cost without the need for purchasing an expensive enclosure/housing. Some of the countries most prestigious museums and historical sites are now protected using AAC Eurovent Ltd’s ‘PR’ filters and frames installed in AHU’s.
All necessary parts are provided for either front access or side access and once the internal dimensions have been provided to AAC Eurovent Ltd only hand-tools and labour are required by the AHU manufacturer.
The AAC AHU Swiftkit® is specifically designed for Air Handling Unit manufacturers to incorporate Activated Carbon Filters into their AHU's at low cost without the need for purchasing an expansive enclosure/housing. Some of the countries most prestigious museums and historical sites are now protected using AAC Eurovent Ltd's 'PR' filters and frames installed in AHU's.All necessary parts are provided for either front access or side access and once the internal dimensions have been provided to AAC Eurovent Ltd only hand-tools and labour are required by the AHU manufacturer.
|
Features & benefits of the AAC Swiftkit® system:-
-
Low cost.
-
Easy to install.
-
Plastic refillable filter system.
-
AAC Colourcell® filter system.
-
Standard parts (usually ex-stock)
-
Easy to retrofit on site.
|
 |
Five easy steps to installing the AAC Swiftkit®
|
Step 1.
|
Plan filter layout (typical layout shown) for positioning of vertical support channelling dictated by the filter sizes.
|
1. Galvanised m/s bulkhead fabrication (AH001) if required.
2. Galvanised m/s 90º bracket (AH002).
3. Galvanised m/s channelling of proprietory manufacture (AH003).
4. Extruded aluminium filter slides complete with brushpile (AH004).
|
Step 2.
|
Fix bulkhead into position on rear wall if required to take up any excess space in the AHU unit.
|
|
Step 3.
|
Fit vertical support channelling (AH003) into position.
|
|
Step 4.
|
Apply foam to rear wall/bulkhead and door panel using self adhesive sponge.
|
|
Step 5.
|
After determining the spacing for the aluminium extrusions, the aluminium extrusions are then fixed in place using a pop riveter and adhesive backed brush pile is applied.
|
Spec. Sheet
Click Here to enquire about this product
AAC Eurovent is continually improving its products & reserves the right to alter its designs, product range at any time. |
